Page 1 of 1
Stopper's trigger shoe question
Posted: Wed Mar 03, 2004 4:31 pm
by Walter
Is there a definite benefit from training with the trigger shoes as sold by Stopper?
Their website is down right now, so I can't post a pic. of it, but I ordered one to try.
A friend of mine put a screw in the middle of his trigger so as to be able to consistantly place the finger the same each time. It is somewhat similar to that.
Are there any drawbacks from such a shoe?
Walt
Re: Stopper's trigger shoe question
Posted: Wed Mar 03, 2004 4:45 pm
by Len_R
I like the Mec trigger but anything that helps promote consitency and is useable to you should be helpful.
Posted: Wed Mar 03, 2004 10:36 pm
by Walter
It's different from that trigger.
Stopper Trigger Blade
Posted: Thu Mar 04, 2004 1:53 am
by Ed Knutson
Walter:
The trigger blade that I believe you are referring to is very much the same as the Anschutz #9716. The advantages to either of these trigger blades are that they are adjustable for lever length, so you can locate your finger in the trigger guard up or down for maximum comfort and clearance and that they offer a "point contact" reference. With most other trigger blades you can get your finger higher or lower on the blade which effects both position considerations as well as the actual effective pull weight required to release the shot. With the "point contact" trigger blade, your finger can only really touch the trigger at the one length and the pull is more consistent. To verify this, use a trigger pull gauge on a standard trigger blade at the very bottom, then move the gauge up a bit and try the pull again, it will be different.
Overall, these kind of trigger blades tend to offer a more consistent trigger finger location and trigger pull release weight.
Ed Knutson