Hammerli 208/215s pressure plunger
Posted: Thu Feb 15, 2024 1:18 pm
I am going to replace some springs and need to replace the pressure plunger because it's chewed up on the outer screw slots. I had the hardest time adjusting the trigger because of this, the hex head inner screw is in good shape.
I haven't done this before and want to know if it is as simple as screwing it out completely and replacing it with the new one. From what I can see on the diagrams I don't see any springs or detent balls to lose. Other than replacement and readjusting the barrel it se
I haven't done this before and want to know if it is as simple as screwing it out completely and replacing it with the new one. From what I can see on the diagrams I don't see any springs or detent balls to lose. Other than replacement and readjusting the barrel it se