Page 1 of 1
Manurhin MR38 Match rear sight blades
Posted: Sat Oct 08, 2022 5:31 pm
by radjag
I have just bought one of these fine revolvers and on carefully looking at the extended rear sight I discover that the sight blade unit is removeable. The one supplied with the gun has a notch 3.1mm wide. It is stamped #1. I prefer a wider notch. I am guessing that Manurhin offer blades with different widths (the rear sight is, I believe, common to both the 32 and 38 Match models). In the past when asking questions of the current USA Importer (Beretta), I have not go much of a response.
Anyone know where I might find Manurhin Rear Sight Blades?
Re: Manurhin MR38 Match rear sight blades
Posted: Sat Oct 08, 2022 7:55 pm
by David M
Old manufacture Manurhins came with extra rear blades of different sizes.
Also used to have different front sights and barrel weights, have not seen these offered since Champus/Beretta took over.
Maybe buy spare rear sight and file it bigger.
Re: Manurhin MR38 Match rear sight blades
Posted: Sun Oct 09, 2022 3:38 pm
by David M
Manurhin Match Rear sight Notch set, part No 643
Re: Manurhin MR38 Match rear sight blades
Posted: Mon Oct 10, 2022 6:40 am
by Rover
"Maybe buy spare rear sight and file it bigger."
Works for me, but you needn't buy a spare.
Re: Manurhin MR38 Match rear sight blades
Posted: Wed May 31, 2023 11:00 pm
by Two Shanks
Ken Buch should be able to answer all your questions
Re: Manurhin MR38 Match rear sight blades
Posted: Thu Jun 08, 2023 2:02 am
by top end
My recent MR38 Match came with 3 rear sight blades, each stamped with a different number. Unfortunately they were all the same width, 3.1mm. Milled one of them out to 4mm. I was also not impressed with the rear sight elevation screw detent notches, which hardly existed. Sent the gun back for a repair. It came back better, but still not as good as older models that I have had.