Page 1 of 1
Converting the fwb 601 to pcp
Posted: Sat Jan 08, 2022 1:15 pm
by Tangohammerli
Can the FWB 601 BE CONVERTED TO P70 status??
Re: Converting the fwb 601 to pcp
Posted: Sat Jan 08, 2022 6:35 pm
by marky-d
I don't know much about these specific guns, but I highly doubt it. Not only are you talking about removing the entire pump mechanism, but then you'd have to figure out how to install a regulator to drop the PCP pressure to something reasonable. Even then, I assume the valves work differently between a SSP and PCP -- I assume the SSP releases all the pressure each time the trigger is pulled, whereas the PCP needs to release only a finely controlled amount on each shot.
marky-d
Re: Converting the fwb 601 to pcp
Posted: Mon Jan 10, 2022 11:31 am
by spektr
The answer is yes.
If you have a lathe and mill and want to do it bad enough. In the end you will have a lot of time invested in something that doesn't need to be converted. You can buy brand new stuff for less than inventing a path to conversion. I wouldn't touch this as a project.
Re: Converting the fwb 601 to pcp
Posted: Mon Jan 10, 2022 1:57 pm
by Shooterer
Re: Converting the fwb 601 to pcp
Posted: Tue Jan 11, 2022 4:49 pm
by pdeal
Major league project. Forget it. Sell the 601 and buy a P70.