TargetTalk

I need the screws that connect a 5018 trigger to a 1907 Anschutz action. any Idea where I can get these?

I tried contacting Anschutz North America and am waiting response. any other options for parts?
-Trevor

I think I have some. If Anschutz NA doesn't pan out PM me. I looked and I have a bag of what I think are the front screws and a bag of the back screws. I'd want to verify, by checking them on one of my rifles first, but I think that's what they are. I'd prefer to let the guys that sell parts for a living try to supply them to you first though.

Thanks for the post. I will try contacting them again and get back with you if they are not responsive.
-TH

Pdeal,
Do you know what the size/thread pitch is? I am also looking for screws on McMaster-Carr. The ANS manual says 46-1 & 45-1 screws but I don’t see a corresponding size on the McMaster site.

They are probably around m3, m4 or m5, but could also be a fine pitch. I'm betting a set of $0.80 screws will cost you above $30 at ANA.

M3.5 X 0.6 and M5 X 0.8

gstewart has it right. The screw lengths are 17mm for the m5 front screw and 11.6mm for the m3.5 rear screw. They have an integral flat washer/lock washer combo that results in an effective length of 14.4mm for the front screw and 9.7mm for the rear screw.

Although they sell primarily action screws, https://www.jnpgunsprings.com/ANSCHUTZ-PARTS-c20967359 , might also have other high quality screws in the size you need.