TargetTalk

We are looking to build an multi-valve fill station, like the ones used at CMP or FT Benning. Does anyone have a parts list or a company that builds these?

They have a really neat one at USA Shooting Center in Colorado Springs. Took a StackOn safe on its side and ran a pipe through with every possible fill adapter. Pipe goes through the wall to a big tank and commercial air compressor. By using a Stack on safe they can lock it when they have to.

Chip

Here is what the Olympic Shooting Center built.

The box is a cheap SnapOn gun safe. That way the can easily lock it when not in use.

Just curious; does that supply air only at 200 BAR?

I have a picture of the compressor and main air tank on the other side of the wall. Both the compressor and the air tank can go up to 4500 psi--but I did not look to see if they limit it to 3000 psi (200 BAR)

Chip

It is limited to 200 Bar out at the fill station.
Good time for a reminder to never look at the manometer from in front of it, particularly while filling.

So what compressor (make/model) are they using?

I looked at a picture and it says Airetex

One of these. http://www.airetex.com/a45.html May not be that exact model.

Search paintball HPA fill panels. Many different regulated or unregulated pushbutton and lever models available.

https://www.google.com/search?q=paintba ... 0&bih=1125

Also SCBA fill stations.