Page 1 of 1
Scatt USB Question
Posted: Sun Mar 19, 2017 6:45 pm
by glenn andrew
I recently pulled out my little used Scatt USB only to discover that I have misplaced the "Target interface cable — used to connect the electronic target to the control unit" . Can anyone let me know what type of cable this is so that I can try to purchase one locally.
Thanks in advance
Glenn
Re: Scatt USB Question
Posted: Mon Mar 20, 2017 11:47 am
by Heddok
It's just a standard telephone cable, pick up a really cheap one at Princess auto or even the Dollar store.
Re: Scatt USB Question
Posted: Mon Mar 20, 2017 7:18 pm
by JW
Just to add a little bit to this.
It might depend on what the standard phone cable is where you are. The USB Scatt units I've seen have used 6 core cable with a 6P6C plug (RJ25).
Standard phone cable this part of the world is 2 core with a 6P2C (RJ11) plug, so it will insert into the jack, but the Scatt won't work.
If you can get your hands on 6 core cable with RJ25 plugs, perfect. Otherwise the easiest way is probably to buy some RJ25 plugs and crimp them onto a length of ethernet cable (trim away the 4th pair).
Not recommended, but in a pinch you could get probably get away with an pre-made ethernet cable (RJ45 8P8C plugs) and grind off the end connector on each side to bodge them down to the size of a RJ25 sized plug. Seen it work, but easy to damage to the pins, so caveat emptor on that route.