Page 1 of 1

Target pasters dispenser

Posted: Wed Dec 28, 2011 9:57 pm
by nockon
I just received my order of target patches but the roll is not threaded. I know if I do it right, they will self dispense. Anyone have a clear set of instructions on how to do this?

Cheers

Posted: Thu Dec 29, 2011 3:14 am
by David Levene
I've yet to find a dispenser that is quicker than going straight from the roll.

Just load a patch on each of the four fingers each time.

Posted: Thu Dec 29, 2011 9:28 am
by nockon
Thanks for the tip but I remember when I was in the military using those types of boxes and when they were fed properly worked really well.

Still looking folks if someone has the knowledge, please share...

Posted: Thu Dec 29, 2011 7:00 pm
by tedbell
Are you referring to the small cardboard box dispensers? If so, I could post a picture of the setup (but wanted to check to make sure I was thinking of the right thing before I went through all that work. ;) )

Thanks,
Ted

Posted: Thu Dec 29, 2011 7:24 pm
by nockon
Yes, the little box with the roll in it. Would really appreciate a pic.

Cheers,

Claude

Posted: Thu Dec 29, 2011 8:04 pm
by tedbell
Image

Here it is. The strip from the roll comes out of the box at the corner but then is held against the side by a tab on the box that closes down over it, causing the strip to make a sharp angle at the corner which is what causes the paster to peel off. Looking at two new boxes I just got, they are larger boxes that don't have that tab, which is key. The new boxes are just regular plain-Jane boxes, so if those are what you have I doubt they can be set up to self dispense.

Hope this helps.

Thanks,
Ted[/img]

Posted: Thu Dec 29, 2011 10:30 pm
by nockon
Yes same box as you have. Thanks for the picture. Was there a piece you had to cut off at that exact spot where the patches come out? I tried that way but that piece I'm talking about was getting in the way. It appears from your pic that you ripped or cut that tab out.

Cheers,

Posted: Fri Dec 30, 2011 7:10 am
by tedbell
No, I didn't have to cut anything off - they actually came set up that way. But I just looked at the box and noticed those tabs you are referring to are there on the inside just under the box lid- the one on that side is pushed down inside the box flat against the side.

Thanks,
Ted

Posted: Fri Dec 30, 2011 7:17 am
by nockon
OK, thanks a lot for helping out Ted. Much appreciated

Cheers,

Claude

Posted: Sun Jan 01, 2012 6:43 am
by Guest
Go to the post office and purchase a small plastic dispenser for a roll of coiled stamps for about a dollar. The entire package easily fits in the dispenser, it is very small, and feeds the pasters through a small slot.

Posted: Sun Jan 01, 2012 6:20 pm
by nockon
But do they half come of as it is the case with the box they come in?

Cheers,

Claude

Posted: Sun Jan 01, 2012 6:46 pm
by Spencer
if you have it set up OK the patch starts to peel off the backing paper