My 162 E has gone on the fritz. A battery corroded and leaked in the fire control circut board. I cleaned it, but new batteries in, able to dry fire a few times. Today, it will not do anything. It needs some other trigger attention and maybe seals.
Where is the best place to send a Morini for some work.
Thanks,
Lee
Morini 162 gunsmithing
Moderators: pilkguns, m1963, David Levene, Spencer, Richard H
Forum rules
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
162 PROBLEM
I hope my experience may helps.
I had a similar problem with my free pistol, 84E. I checked that may be some oil has corroded the contacts of the capacitor on the electronic board (probably while cleaning after each session and sometimes I used some WD40 to remove the grease on the frame, or may be its time had come. Anyway I visit to local electronic supplies and change a new capacitor solved the problem. Perhaps you can use an equipment to check the capacitor's functioning.
P.S. I mean the black fire cracker like part on the board.
I had a similar problem with my free pistol, 84E. I checked that may be some oil has corroded the contacts of the capacitor on the electronic board (probably while cleaning after each session and sometimes I used some WD40 to remove the grease on the frame, or may be its time had come. Anyway I visit to local electronic supplies and change a new capacitor solved the problem. Perhaps you can use an equipment to check the capacitor's functioning.
P.S. I mean the black fire cracker like part on the board.