Page 1 of 1
Morini CM84E two stage trigger version
Posted: Wed Feb 02, 2011 2:01 pm
by zohan
How can I change one stage trigger version to the two stage version?
Is it possible? I can't find any conversion from Morini.
Thank you
Posted: Wed Feb 02, 2011 2:25 pm
by Tycho
You need a complete replacement trigger module. Don't know if Morini has any in stock. When I got my one three years ago, it was still in beta stage. Replacing it is no problem, just take the single stage out and put the new one in, it's one screw and one bolt, if I remember correctly. Two minutes work.
Posted: Thu Feb 03, 2011 10:38 am
by A74BEDLM
On the subject of CM84E's.
Is the original Morini Grip less raked then replacement Rink?
I have a Rink on mine and I get a pain in forearm with triggering sometimes - like a stretched tendon or something.
Posted: Fri Feb 04, 2011 8:03 am
by A74BEDLM
2 stage triggers available direct from Morini CHF350.00
Posted: Sat Feb 05, 2011 5:49 pm
by Tycho
I'd say the Rink and the Morini grip are more or less similar in their angle, but they are hard to compare, as the general concept is very different. I can't get the Rink to fit my style at all, so I'm using a modified Morini. Both of them are rather upright for a FP grip, IMO - other brands are raking their FPs much more. Angling up would be easier than raking it more, as the electronics get in the way when you start to cut the fingers deepers into the grip.