Daisy 717 Rear Sight
Posted: Sat Nov 21, 2009 6:41 pm
I don't have to tell you all about the 717 rear sight issues, lets just say that they leave a little to be desired. So, after a little thought, I came up with this solution. I carved a piece of aluminum to fit the hole the original sight came out of and fitted a Micro sight for a M1911 to it. The new sight base is retained to the side plates by a screw from the bottom. Except for the screw access hole in the bottom of the side plates, and a slight clearance cut in the top rear corners of the side plates, no other changes are made.
If I was going to do it over again, I would attempt to find a target quality sight with a smaller dovetail. That would allow the sight to be installed more to the rear and make the notches in the top rear corner of the side plates unnecessary.
Tks, Bill
If I was going to do it over again, I would attempt to find a target quality sight with a smaller dovetail. That would allow the sight to be installed more to the rear and make the notches in the top rear corner of the side plates unnecessary.
Tks, Bill