Just got a new one and the manual says nothing, other than that it should be serviced periodically by a gunsmith.
So.... outside of the pivot points when the gun is cocked, where else would need to be lubed? I'm thinking mainly for the piston/seal. Perhaps just a light coating of Pelgunoil on the shaft that goes in and out of the compression chamber?
Thanks for any help! :)
Lubrication points on a Gamo Compact?
Moderators: pilkguns, m1963, David Levene, Spencer, Richard H
Forum rules
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
-
JulianY
- Posts: 350
- Joined: Fri Oct 13, 2006 6:26 am
- Location: A british shooting refugee in Amsterdam
- Contact:
To be honest I have had mine for 15 year and never dont anything to it and it's still goine fine. The one proble i did have was the the blade that holds the barel in place bent after about 10 year, so i made a new one.
I would perhaps put a drop on the piston lever joint. Not knowing what the seal is made of I would not put any oil near it.
Julian
I would perhaps put a drop on the piston lever joint. Not knowing what the seal is made of I would not put any oil near it.
Julian