Page 1 of 1

LP10 grip change

Posted: Mon Aug 28, 2006 5:25 pm
by darticus
Does anyone know if just changing grips can change pistol set up, if both grips are set the same.That means does the screw that mounts the grips cause a change in position of the grip to gun or does it just mount it straight on?

Re: LP10 grip change

Posted: Mon Aug 28, 2006 10:03 pm
by Fred Mannis
darticus wrote:does the screw that mounts the grips cause a change in position of the grip to gun or does it just mount it straight on?
Ron, see section 7 in your owner's manual 'Adjusting the Grip'. It is possible to inadvertantly change the position of the grip relative to the gun when remounting the grip and tightening the grip mounting screw.

Re: LP10 grip change

Posted: Tue Aug 29, 2006 2:03 am
by RobStubbs
darticus wrote:Does anyone know if just changing grips can change pistol set up, if both grips are set the same.That means does the screw that mounts the grips cause a change in position of the grip to gun or does it just mount it straight on?
In theory there should be no change since there are screws in the frame that fine tune the grip and level it up. The grip mounting screw/rod should just lot up the stting. It is however possible to mis seat the grip if you are clumsy but I've never had any problems and my grips come off quite often.

I suspect you may be asking if you can just swap grips - perhaps between person a) and b). I would say that should be no problem, just make sure the grips are properly seated each time.

Rob.

Thanks all

Posted: Tue Aug 29, 2006 1:55 pm
by darticus
Will check it out.Wanted to use my lp 1 grips on my lp 10 without getting out of adjustment. Thanks