Page 1 of 1
Target Overlay
Posted: Mon Jun 19, 2006 8:55 am
by Bobp
Does anyone know where I can get target overlay's for resconstructing the scoring ring of a target for ISSF 25/50M and rapid fire pistol targets.
Posted: Tue Jun 20, 2006 10:10 am
by Bobp
If no one can help with a supplier does anyone know what they look like or the specification to produce one.
Posted: Tue Jun 20, 2006 11:02 am
by David Levene
You could try the
ISSF Shop. I "believe" that what they call "Foils" are the overlays (but check with them before ordering).
I actually purchased some Lapua branded ones in Finland about 8 years ago.
Are you the BobP I think you are. If so then why didn't you ask me at the weekend ;-)
Re: Target Overlay
Posted: Tue Jun 20, 2006 1:57 pm
by Fred Mannis
Bobp wrote:Does anyone know where I can get target overlay's for resconstructing the scoring ring of a target for ISSF 25/50M and rapid fire pistol targets.
If you can't find a source, then make your own. Scan a paper target into your PC, then print it out on overhead transparency film. Or use use target software, like Pellant, and print the target as above. If you just need to reconstruct a ring for scoring, you don't need to copy the entire target.
Re: Target Overlay
Posted: Tue Jun 20, 2006 4:20 pm
by RobStubbs
Fred Mannis wrote:Bobp wrote:Does anyone know where I can get target overlay's for resconstructing the scoring ring of a target for ISSF 25/50M and rapid fire pistol targets.
If you can't find a source, then make your own. Scan a paper target into your PC, then print it out on overhead transparency film. Or use use target software, like Pellant, and print the target as above. If you just need to reconstruct a ring for scoring, you don't need to copy the entire target.
You'll need a bloody great scanner and printer for 25M rapid targets !
Rob.
Posted: Wed Jun 21, 2006 7:55 pm
by John Hollingshead
Posted: Thu Jun 22, 2006 1:34 am
by Spencer
are these for NRA or ISSF targets? the cat #RIG Products SO10 appears to be for NRA
Posted: Fri Jun 30, 2006 3:47 am
by Bobp
Thanks for all your replies, I would have monitored the forum more Often but have had no email acknowledgements of further posts.
I seemed to have found what I was originally looking for in the ISSF shop hiding at the bottom. Unfortunately I will have to purchase the whole set which is for all ISSF events (only want the pistol ones). I was sure that Lapua had produced them at one time which has been proved to me by D. Levene. Lapua just stated that they do not make such a thing, well when they were involved it was a long time ago. I could get some made by a local company to me using an A1 size photgraphic lazer scanner but that would cost even more.
Does anyone know a supplier of a shot hole scoring overlay for ISSF pistol calibres other than Gehmann's Illuminated scoring gauge. This tool is large and bulky, you used to be able to buy the overlay part of this tool in a 35mm transparency holder.
Bob