Page 1 of 1
AW93 trigger
Posted: Sat Jun 18, 2005 11:48 pm
by guest22
I saw an AW93 and the groove to hang the test weight does not appear anywhere near the middle of the trigger.
Given 8.4.2.6.1 The weight of the trigger pull must be measured, with the test weight suspended near the middle of the trigger, does the AW93 trigger meet the requirements?
Posted: Sun Jun 19, 2005 12:09 am
by David Levene
There is no requirement in the rules for there to be a groove on the trigger.
If there is a groove but it is not in the appropriate place then the equipment control staff should just ignore it. This can obviously be difficult if the trigger slopes backwards as the weight will tend to slide. The rubber knife-edge option can make things easier but, IMHO, the onus is on the competitor to present a gun that that is capable of being tested. This means that if there is a backward sloping trigger without a slot in the correct position and the testing weight will not stay in the correct position by itself then the pistol must fail.
Posted: Sun Jun 19, 2005 6:27 pm
by Walter
The groove on mine is in the middle.