Anybody have the factory spec for the overall length of the firing pin for a Hammerli 208 - or a new friring pin they can measure?
Spencer
Hammerli 208 firing pin
Moderators: pilkguns, m1963, David Levene, Spencer, Richard H
Forum rules
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
-
Shooting Kiwi
- Posts: 321
- Joined: Fri Apr 20, 2007 3:33 am
- Location: New Zealand
Hi Spencer,
Have just removed firing pin from a very lightly-used (by previous owner) 208. It looked almost unused. Since acquiring it recently, I suppose I've put less than 500 rounds through it.
Overall length of firing pin: 41.50mm (1.634in) according to my known-accurate digital vernier. I can't believe that the hammer wear has shortened it more than a couple of thou (0.001").
Hope this late info. is of use.
Have just removed firing pin from a very lightly-used (by previous owner) 208. It looked almost unused. Since acquiring it recently, I suppose I've put less than 500 rounds through it.
Overall length of firing pin: 41.50mm (1.634in) according to my known-accurate digital vernier. I can't believe that the hammer wear has shortened it more than a couple of thou (0.001").
Hope this late info. is of use.