Toz 35 Firing Pin Spring Length

[Swoffer]

Does anyone know the length of the firing pin spring in the Toz 35 when new? I have had a couple of light strikes so I have dissembled the firing spring assembly and cleaned everything. I measured the spring and it is 26mm but I dont know the correct length. Just wondering if has compressed a bit and I need to try and source a new one from who knows where???

[David M]

A good replacement spring for a Tos 35 firing pin spring is a S&W M14 rebound spring either 14 or 15 lb.

[j danielsson]

The firing pin from any pardini free pistol will fit.

[Oldnslow]

The spare (unused) firing pin spring that came with my Toz 35m is 27.5mm long.

[Swoffer]

The spare (unused) firing pin spring that came with my Toz 35m is 27.5mm long.

Thanks Oldnslow, that's exactly what I needed to know. Mine has shrunk then, the pistol was probably stored with the spring under pressure by a previous owner.
Cheers

[Rover]

A good replacement spring for a Tos 35 firing pin spring is a S&W M14 rebound spring either 14 or 15 lb.

Yeah but.....I have both used and sold these. The TOZ is kind of a sloppy build, so the necessary spring length can vary.

Sometimes I use a cut-off on my Dremel to shorten a spring about a coil. Actually, I'm getting ready to put one in my
TOZ right now. The old one lasted about 10 years before the misfires started.

[JariN]

The firing pin from any pardini free pistol will fit.

I recommend this one if you have a source for Pardini spare parts.
Pardini K22 or K50 firing pin spring is a direct fit. No need for dremelling.

[brent375hh]

The firing pin from any pardini free pistol will fit.

The firing pin or just the spring?

[j danielsson]

The spring. Sorry.