Greetings all,
Since running target 4x scopes are nearly impossible to acquire, I have read that some scopes can be re-parallaxed to 10 m. Does anyone have done so?
Kindest regards,
N
Re-parallax 4x scope?
Re: Re-parallax 4x scope?
In general, to do this you need to unscrew objective near 1-2-turns (circa 0.5-1mm). After you should find position of objective with best sharpness on 10m. And next step you will measure gap between objective assembly and scope body , and find any copper, steel or aluminium wire with corresponding diameter and make ring from it and insert it into the gap and tighten objective.
Re: Re-parallax 4x scope?
Forgive me for tagging on here, but I've always wondered about re-parallaxing a scope. What if the scope is gas filled? Will the process compromise the seals, and allow air to enter the scope?
To the OP, are you considering re-parallaxing a RT scope, or just a 4X scope? If the latter, why not buy one that does focus to 10M?
To the OP, are you considering re-parallaxing a RT scope, or just a 4X scope? If the latter, why not buy one that does focus to 10M?