hi folks, yesterday i took delivery of a seal kit for my k12, i had previously downloaded the exploded diagram from pardini Italy,the kit contains 18 parts, most of witch i can identify through elimination and direct substitution, however this still leaves me with 4 seals that i cannot identify from the diagram (3 "0" section and 1 small square section), there are no individual part numbers with the kit that could be referenced against the diagram , is there any information out there to help identify individual seals and there location in the pistol.
thanks in advance.
a10ken
k12 seal kit question
Moderators: pilkguns, m1963, David Levene, Spencer, Richard H
Forum rules
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
-
thirdwheel
- Posts: 205
- Joined: Sat Feb 08, 2014 2:16 pm
- Location: England
Re: k12 seal kit question
Like you had a bit of a head scratch, think those are extra breech seals for good measure, the square section one not sure as I've not taken my k12 down to service it and only will do so when it warrants it.
Re: k12 seal kit question
cheers 3rdwheel, mine had to come apart as it was loosing pressure overnight with a cylinder attached.
the three "o"section rings do appear to be breech/transfer port seals , but as for the square section one i have no idea??
the three "o"section rings do appear to be breech/transfer port seals , but as for the square section one i have no idea??