Changing cylinders during a match...

[DFWdude]

The rule says:
"6.11.2.3 If an athlete wishes to change, or to fill, a gas or air cylinder, he must leave the firing point to do so, after obtaining permission from the Range Officer. No extra time is allowed to change or fill a gas or air cylinder during a competition."

All understood. However, what is the accepted procedure for leaving the firing point? Get permission first, no problem. But, do I have to rebox the pistol, or carry it open muzzle up or down? And is there some designated area (in the range or off) where I can make the change without distracting other shooters? Anything else to consider?

[rmca]

Open the bolt and insert the safety flag until it shows on both sides of the barrel. Leave the gun on the table pointing forwards.
Raise your arm and wait for the referee to come to you. Don´t disturb the other shooters.
Tell him or her that you need to change cylinders.
Do as him or her instructs.

Hope this helps

[Rover]

You don't need to mess with the pistol at all; just the empty cylinder. If you're fortunate (as if you're shooting at the Desert Midwinter) just go to the office and refill. Nobody cares.

[David Levene]

And, as is fairly common, Rover gives an answer which is nothing to do with the original question.

[Rover]

Of course, I could not have been more plain or direct.

[DFWdude]

Of course, I could not have been more plain or direct.

Rover, if only you had paid any attention to this thread... http://www.targettalk.org/viewtopic.php?f=4&t=54122 .... you would know the genesis of this one. But of course you did, as you posted an equally useless comment there as well... Something like, "It's obviously time for a total rebuild of your gun including a new regulator. Ya shoulda bought a pumper." How useful...

We're discussing how to remove the cylinder while not breaking a rule.

I realize you have so many threads needing your attention. Maybe you can slow down when you reach 5,000 posts. Meantime, if you insist on being the forum PW, please try to keep up by reading enough to comprehend before posting.

[David Levene]

Of course, I could not have been more plain or direct.

...but nothing to do with the original question which was about the correct procedure under ISSF rules.

[Spencer]

Open the bolt and insert the safety flag until it shows on both sides of the barrel. Leave the gun on the table pointing forwards.
Raise your arm and wait for the referee to come to you. Don´t disturb the other shooters.
Tell him or her that you need to change cylinders.
Do as him or her instructs.

Hope this helps

Pretty much nails it.
The Range Officer (not referee):

• - will check that the pistol is safe and may well require that it be boxed.
  - tell you where the firearm is to be taken to change / re-charge.
  - check you back into your firing point

You don't need to mess with the pistol at all; just the empty cylinder...

Rover misses the reason that the rule was introduced; i.e. to stop shooters from unscrewing cylinders and reattaching cylinders (with an attendant 'whoosh') on the line. There were competitors who did so just as another competitor was about to fire a shot...

[Rover]

I'll buy your reasoning, but what about the guy blowing the vuvuzela behind his head?

[TenMetrePeter]

most of our shooters are between 60 and 80 and flatulence has a similar unnerving effect.