Hello,
I am looking for the O-Ring on the SAM M10 air pistol.
On their manual it says number 1202.
In the manual there is no dimensions for the O-ring. The company does not respond to emails (obviously).
I'd be happy to know the dimensions of the O-Ring. It's inner diameter is slightly under 3mm and the thickness should be thicker than 1.5 but appears to be thinner than 2mm. I tried several, even the one from a Morini 162 (O-Ring 162010A), from a similar part, with similar dimensions.
It's a freaking O-ring, and replacing it would make the pistol functional again! Any help is appreciated. You can overcharge me for that thing^^
SAM M10 O-Ring
Moderators: pilkguns, m1963, David Levene, Spencer, Richard H
Forum rules
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
Re: SAM M10 O-Ring
From your measurements, a 1.9mm wide by 2.8mm ID O-ring should be close. That is a standard size. If it's used at full SCUBA pressure, you should try to get a hard O-ring, like a durometer rating of A90, instead of the more common A70. Here's one that is A75:
http://www.mcmaster.com/#9263k636/=12hwp72
http://www.mcmaster.com/#9263k636/=12hwp72