Walther grip question

[Leon]

Does a grip for a LP300 fit a GSP?

I've just bought a new grip on egun, ostensibly for GSP, but the seller has informed me that some people had emailed him telling him that the grip was for an LP300.

He did say that it has been tried on a GSP ( not screwed ) nut I don't want to make an expensive mistake....

Picture of grip here - http://www.egun.de/market/item.php?id=5174454

Anybody?

[David M]

The part numbers for the LP300 grip and the GSP do not match.
http://www.carl-walther.de/public/downl ... 662094.pdf
http://www.carl-walther.de/public/downl ... 662094.pdf

[ghostrip]

mount hole for the two grips are completely different. also even if you successfully screw the lp300 on to a gsp i am pretty sure total dimensions will not comply with issf rules (most of the gsp with their original grips i have seen are a very tight fit in the issf rule box). perhaps you should contact your seller and mutually cancel your winning bid.

[David Levene]

I know that pictures can be deceptive with nothing to reference them against but I would be suspicious of this being a GSP grip.

I could easily be wrong but the rear overhang appears to be greater than the 30mm allowed.

[JamesH]

I'm 100% sure that's not for a GSP, more likely an LP300.

[Leon]

Thanks guys - the seller and I have mutually agreed not to proceed with the sale...

[Crete]

GSP Expert on the left and LP300 on the right.