Installing a Morini Compensator in a Pardini

[tqb]

Hello,

Is it possible to remove the Front sight holder of a Pardini PGP 75 in order to install a Morini Compensator?

Thank You.

[Gwhite]

If I remember correctly, all you have to do is remove the front sight blade. There is a set screw down inside the hole for the sight blade that I _think_ clamps the sight block to the barrel. They show this arrangement in the manual, but in a separate drawing from the exploded view. Oddly enough, the set screw isn't shown in the exploded diagram, and I can't find it on the parts list either.

It's also possible that the screw shown is used to set the height of the front blade. In which case there may be a second screw underneath that locks the sight block to the barrel.

[tqb]

Thank You.

I will try to find the screw in the morning.

Thank You again.

[ModestoPete]

What is the status of your modification? Did it go on?

If so, did you get the performance you were looking for?

[ModestoPete]

Were you able to install a Morini Compensator?

[Fred Mannis]

I installed a Morini compensator on my Pardini K22. Taking off the front sight was easy. I had to fabricate a bushing since the Pardini barrel OD is less than Morini compensator ID.