CLEANING RODS 22LR, .30 cal.

naimman · Post by **naimman** » Wed Mar 20, 2013 11:15 am

Need to purchase new rods, however there seems to be many brands/types out there. I know 1 piece is best, but which ones/brands are best for my rifles. Thanks.

joel · Post by **joel** » Wed Mar 20, 2013 11:57 am

I use the Tipton carbon fiber one piece cleaning rod. Be sure to get an insert to put in place at the breach when you take the bolt out.

Joel

naimman · Post by **naimman** » Wed Mar 20, 2013 6:29 pm

Thanks.

Rover · Post by **Rover** » Wed Mar 20, 2013 6:44 pm

Do not use aluminum: abrasive grit will embed in the rod and wear your barrel. Use one-piece steel (or coated) with a bore guide.

randy1952 · Post by **randy1952** » Thu Mar 21, 2013 1:56 am

naimman wrote:Need to purchase new rods, however there seems to be many brands/types out there. I know 1 piece is best, but which ones/brands are best for my rifles. Thanks.

I use a Dewy brass rod or their coated nylon rod.

Eric U · Post by **Eric U** » Thu Mar 21, 2013 9:50 am

I've tried the Tipton carbon rods and they are nice...never going to bend one. Only problem is the carbon can be very abrasive, is harder than steel, and will probably eventually erode the crown area of your barrel. It may not matter much on a centerfire rifle as their lifespan is measured in 1000's of bullets, but a rimfire barrel should last 10,000's of thousands of rounds and cleaning routines can affect barrel life.

Eric U

joel · Post by **joel** » Thu Mar 21, 2013 10:13 am

Eric U wrote:I've tried the Tipton carbon rods and they are nice...never going to bend one. Only problem is the carbon can be very abrasive, is harder than steel, and will probably eventually erode the crown area of your barrel. It may not matter much on a centerfire rifle as their lifespan is measured in 1000's of bullets, but a rimfire barrel should last 10,000's of thousands of rounds and cleaning routines can affect barrel life.

Eric U

Yes, good point. I usually don't push the rod out the front far enough to expose the carbon rod. Also, I inspect the rod to ensure that the clear coat is still intact on the carbon fiber and that the raw carbon is not exposed.

Joel

tenring · Post by **tenring** » Sat Mar 23, 2013 12:03 am

look for Ivy Rods on the net. I've got four of them now and they are superb!

Great People to do business with!

tenring

Mikey_P · Post by **Mikey_P** » Sat Mar 23, 2013 8:30 am

tenring wrote:look for Ivy Rods on the net. I've got four of them now and they are superb!

Great People to do business with!

tenring

+1 on the Ivy rods. And, to complete the package, a bore guide from MWerks LLC - top quality!

Mike

TargetTalk

CLEANING RODS 22LR, .30 cal.

CLEANING RODS 22LR, .30 cal.

Re: CLEANING RODS 22LR, .30 cal.