Th newer Walther Free Pistol electronics board used surface mount components and individual headers for wire groups. Does anyone have a picture showing how this board was placed in the gun forearm?
I have an older gun where the power switch threaded bushing passes through a hole in the board and then up through the metal forearm cover. But the newer board appears to have separated the switch from the board. I don’t understand how there was room for both components in the limited available space.
I’ve included a factory drawing of the newer board for detail.
Walther Free Pistol Question
Moderators: pilkguns, m1963, David Levene, Spencer, Richard H
Forum rules
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
-
Bob LeDoux
- Posts: 113
- Joined: Wed Mar 03, 2004 6:08 pm
- Location: Jefferson, OR (near Salem)
Walther Free Pistol Question
- Attachments
-
- Full page fax print.pdf
- (543.41 KiB) Downloaded 168 times