Adjusting the Pardini SP trigger

networkguy3 · Post by **networkguy3** » Thu Jun 30, 2011 1:55 pm

I have just purchased a used SP, and I really like the gun. However, I would like to add some roll to the trigger. Right now I have a moderate-length first stage and then a really crisp second stage, which I'd like to add some roll to. Can anyone tell me which of the screws on the SP trigger module will allow me to do this?

In some ways I hate to change the trigger at all. It is incredible in comparison to the Buckmark I was shooting, and I'd had a trigger job done on the Buckmark. However, I know I can make it even better with some careful work.

Gwhite · Post by **Gwhite** » Thu Jun 30, 2011 6:50 pm

Check out this thread for diagrams of the inner workings:

http://www.targettalk.org/viewtopic.php?t=19268

Also, read Don Nygord's instructions here:

http://www.targettalk.org/viewtopic.php?t=9795

networkguy3 · Post by **networkguy3** » Thu Jun 30, 2011 9:25 pm

Those are great references. Thanks. Now all I have to do is be patient, work slowly and get it right.