FWB 65

PFribley · Post by **PFribley** » Thu Mar 24, 2011 8:55 pm

Purchased an FWB65 4" barrel. Nice shooting pistol. The trigger has too much pre travel for my tastes. The manual outlines an adjustment procedure. I don't want to adjust the trigger. I want to elimate some of the pre travel. Ok you FWB 65 gurus. Do I adjust screw #1 or #2 to eliminate some of the pre travel??? Thanks.

Rover · Post by **Rover** » Thu Mar 24, 2011 10:11 pm

Try them both...then you'll know. You have a 50/50 chance of getting it on the first try.

You can't screw up, just note the amount of adjustment you made so you can go back if necessary. I haven't owned one in a long time, but I don't remember being able to adjust the pre-travel (1st stage).

luftskytter · Post by **luftskytter** » Fri Mar 25, 2011 10:04 am

Look here for a very good manual:

http://www.feinwerkbau.de/ceasy/modules ... PageId=114

pick your model

luftskytter · Post by **luftskytter** » Sat Mar 26, 2011 1:00 pm

Similar thread in Yellow Forum, pointed here:

http://www.pilkguns.com/tenp/default.htm

Good info there.
hmmm, Pilkguns, sounds familiar.......